Home / Building Maintenance / Commercial Glass / Commercial Glass Safety
Commercial glass guide
Glass type affects how it breaks, how well it resists intruders and whether it meets code. Here is a plain-English comparison for property managers.
Standard annealed glass breaks into large, sharp pieces. It is still common in older buildings, but building codes generally do not allow it in locations where people could fall into or push against the glass, such as doors and glass near walkways.
Tempered glass is heat-treated to be several times stronger than annealed glass of the same thickness. When it breaks, it crumbles into small, blunt pieces that are less likely to cause serious cuts. It cannot be cut after tempering, so replacements are made to order. It is widely used in doors, sidelites and storefronts.
Laminated glass bonds two or more layers of glass to a plastic interlayer. When it breaks, the pieces stay attached to the interlayer, so the opening stays closed. That makes it useful for overhead glazing, security, sound control and locations where falling glass would be dangerous.
Impact-resistant glazing is usually a laminated product in a tested frame system, designed to resist wind-borne debris during hurricanes. Some coastal areas require it by code. Security-rated glazing is a related category tested against forced entry or ballistic attack.
| Type | How it breaks | Common uses |
|---|---|---|
| Annealed | Large sharp pieces | Older windows in low-risk locations |
| Tempered | Small blunt pieces | Doors, storefronts, sidelites, partitions |
| Laminated | Cracks but stays in place | Overhead glass, security, railings, sound control |
| Impact-resistant | Stays in the frame under tested impacts | Hurricane zones, high-security locations |
When glass is replaced, the new glass must meet the code for its location today, so confirm requirements with your contractor. Beyond code, think about the building’s risks: break-ins, storms, overhead hazards or noise. Safety glass is usually marked with a small permanent label in a corner, which helps you identify what is already installed.
Property managers look for fast emergency response, current insurance and clear pricing. See what gets a glazing company onto an approved vendor list.
Questions
Look for a small etched mark in a corner of the pane. If there is none, a glazing contractor can usually confirm the glass type with simple tools.
It still cracks, but the interlayer holds it together, so getting through takes much longer. That delay is why it is often used where security matters.
Put entrance, window and curtain wall checks on the annual calendar, and keep an emergency glazing contact on file for every building.
Independent commercial property management education, research, and company information.
© 2026 CommercialPropertyManagement.org. For educational purposes only, not legal, financial, or property management advice.