Home / Building Maintenance / Water Damage Restoration / Fire Sprinkler Discharges

Water damage guide

Fire Sprinkler Discharges: Emergency Response and Building Recovery

Sprinkler discharges release a lot of water quickly. Handling them safely means stopping the water without leaving the building unprotected.

Why sprinklers discharge

  • Freezing pipes in unheated areas
  • Physical damage to heads from equipment, ladders or forklifts
  • Corrosion and old components
  • Overheating near heat sources
  • Work by contractors near sprinkler piping

Stopping the water

Sprinkler systems are life-safety systems. Only trained, authorized people should close control valves. Call the fire protection contractor and alarm monitoring company immediately. The fire department may also respond to the water flow alarm. Once the head is replaced and the system is restored, the contractor should confirm it is back in service.

Fire watch

When a sprinkler system is out of service, fire codes typically require notifying the fire department and, in many cases, a fire watch until the system is restored. Ask your fire protection contractor and local fire officials what is required, and record the impairment and restoration.

Clean-up considerations

Sprinkler water has often sat in pipes for years and may be dirty or contain treatment chemicals. Restoration contractors may treat it as gray water, which can mean more removal of porous materials. Clean-up should start quickly.

Recovery steps

  1. Stop the water and restore fire protection.
  2. Start extraction and drying.
  3. Document the damage and the failed component.
  4. Notify the owner, tenants and the insurer.
  5. Investigate the cause, especially if a contractor or freezing was involved.
  6. Fix the cause, such as heat in cold areas or guards on vulnerable heads.

Prevention

Follow the inspection, testing and maintenance schedule your fire protection contractor sets under NFPA 25 and local fire code. Keep heat in areas with wet pipes, protect heads in storage and loading areas, and require contractors to work carefully around piping. See our annual prevention checklist.

Questions

Common questions

Only if they are trained and authorized under your building’s procedures. Call the fire protection contractor and monitoring company right away in every case.

Often the contractor’s insurance. Document the incident, keep the broken head and give the contractor’s insurance information to the owner’s insurer.

Be ready before the next leak

Label shutoffs, keep an emergency restoration contact on file and schedule the inspections that catch water problems early.